10HP TH5-120-07 230V 3-Phase. Pump-end and Motor

US$1,880.00 US$939.00
(No reviews yet)
104.00 LBS
30.00 (in)
16.00 (in)
9.00 (in)
Current Stock:
Adding to cart… The item has been added

Complete pump end and motor set. Complete Instructions. Control Panel sold separately.


  • HP: 10HP
  • Voltage: 230V Three Phase
  • Cycle: 60 Hz
  • Operating Amperage: 28.5 A
  • Motor RPM: 3450 RPM
  • Stages: 7
  • Maximum Head(cut off): 290 ft
  • Rated Flow: 120GPM
  • Maximum Flow(0-90 ft.): 155 GPM
  • Open Flow vs Depth: 140GPM @ 75ft.; 120GPM @ 160ft; 100GPM @ 205ft; 80GPM @ 260ft
  • Suction Port: Center Suction
  • Discharge Port: 2 inch NPTF
  • Built-in Check-valve: Yes, Stainless Steel
  • Housing Material: Stainless Steel
  • Discharge and Suction Port Material: Cast Iron
  • Impeller Material: Thermal Plastic
  • Motor Enclosure:  BodyStainless steel; Top - Cast Iron
  • Duty: Continuous or up to 20 restarting cycles / hour
  • Control Box: Control Box (Control Panel) Optional
  • Weight: 95 lbs.
  • Dimensions/Length: 49.75"

If you do not purchase a Tuhorse Control Panel for this pump, below is the minimum requirement for operating and protecting the pump.

Minimum requirement for operating the motor is a non-fused 3-phase power switch and a 3-phase overload protector / Circuit breaker. The protector / breaker must be the type of those that shut off all 3-phase when one or more phase is overloaded. Do NOT use a fused switch that could burn out one of the phase. Do NOT use 3 x 1-Phase breakers, You must use a real 3-phase breaker that do not cause phase loss problem.


1 Year