Complete nominal 8" pump-end(wet-end) with 6" motor bracket, and 6" water-lubricated motor. User must fill up distilled water into the motor before running it(roughly 3 gallons).
Fit 8" ID well casing, overall maximum diameter is 7 inches. This model uses water-lubricated motor is for vertical installation only.
Control box (control panel) is not mandatory, but a three phase power switch with overload protection is required.
This full stainless steel, water lubrication pump and motor is recommended for community water system. It is also better for using in lite corrosive water.
HP: 20HP
Voltage: 230V Three Phase
Cycle: 60 Hz
Operating Amperage: 57A
Motor RPM: 3450 RPM
Stages: 2
Maximum Head (cut off): 200 ft.
Maximum Flow( 0-90 ft.): 580 GPM
Rated Flow: 450GPM
Free Flow Rate: 520GPM @ 105ft; 450GPM @ 125ft; 395GPM @ 138ft; 350GPM @ 145ft; 200GPM @ 170ft.
Suction Port: Center Suction, S.S. 304
Discharge Port: 5 inch NPT Female S.S. 304 (5" to 4" NPT adapter sold separately if needed)
Built-in Check-valve: Yes, S.S. 304
Housing Material: Stainless Steel 304
Impeller Material: stainless steel 304
Motor Body and Top: Stainless steel 304
Motor Base: Stainless steel 304
Motor Bearing / Lubrication: Water lubricated thrust bearing, water filled lubrication(user must fill up distilled water into motor)
Duty: Continuous or allow maximum 15 restarting cycles / hour
Control Box: Three phase power switch with overload protection is required(sold separately)
Net Weight: 203 Lbs.
Shipping weight: 228 Lbs.(163+40+25), ship with LTL Freight only, see detail
Dimensions/Length(pump and motor assembly): 65"
Minimum requirement for operating the motor is a non-fused 3-phase power switch and a 3-phase overload protector / Circuit breaker. The protector / breaker must be the type of those that shut off all 3-phase when one or more phase is overloaded. Do NOT use a fused switch that could burn out one of the phase. Do NOT use three individual 1-Phase breakers. You must use a real 3-phase protector / breaker or a protection device that does not cause phase loss (missing phase) problem.
* Not exactly as shown in photos due to stage and HP vary from model. Photos was taken from one of the 8" model for illustrations only.
Shipping information:
Due to the weight of motor is over the 150Lb limit set by regular courier services, this item will be delivered by LTL Freight service. Subject to additional charge if buyer is (1) in rural area, (2)without a forklift truck for unloading, (3) requires appointment, (4)Home delivery. Buyer can ask for delivering to your closest ABF or TForce Freight center for pick up to avoid the surcharges.
Please allow 2 days handling time. This item ship to 48 USA continental states and Canada only. Travelling time is 3-10 business days.
The shipping weight is around 228Lb including packing and the pallet. The motor is 163 Lb. Two person lift is required for unloading if a forklift truck is unavailable.
Tuhorse
Tuhorse
Tuhorse
Tuhorse
