10HP TH5-050-13 460V 3-Phase. Pump-end and Motor

SKU:
TH505013T460
US$890.00
US$1,880.00
(You save US$990.00 )
(No reviews yet) Write a Review
Weight:
95.00 LBS
Width:
30.00 (in)
Height:
16.00 (in)
Depth:
9.00 (in)
Condition:
New
Current Stock:

Complete pump end and motor set. Complete Instructions. Control Panel sold separately.

 

  • HP: 10HP
  • Voltage: 460V Three Phase
  • Cycle: 60 Hz
  • Operating Amperage: 14.5 A
  • Motor RPM: 3450 RPM
  • Stages: 13
  • Maximum Head(cut off): 660 ft.
  • Rated Flow: 50GPM
  • Maximum Flow(0-200 ft.): 70 GPM
  • Open Flow vs Depth: 60GPM @ 320ft; 50GPM @ 420ft; 40GPM @ 520ft.
  • Suction Port: Center Suction
  • Discharge Port: 2 inch NPTF
  • Built-in Check-valve: Yes, Stainless Steel
  • Housing Material: Stainless Steel
  • Discharge and Suction Port Material: Cast Iron
  • Impeller Material: Thermal Plastic
  • Motor Enclosure:  BodyStainless steel; Top - Cast Iron
  • Duty: Continuous or up to 20 restarting cycles / hour
  • Control Box: Control Box (Control Panel) Optional
  • Weight: 95 lbs.
  • Dimensions/Length: 49.75"

If you do not purchase a Tuhorse Control Panel for this pump, below is the minimum requirement for operating and protecting the pump.

Minimum requirement for operating the motor is a non-fused 3-phase power switch and a 3-phase overload protector / Circuit breaker. The protector / breaker must be the type of those that shut off all 3-phase when one or more phase is overloaded. Do NOT use a fused switch that could burn out one of the phase. Do NOT use 3 x 1-Phase breakers, You must use a real 3-phase breaker that do not cause phase loss problem.

 

1 Year