5.5HP TH4-045-12 230V 3-Phase. Pump-end and Motor

(You save US$630.00 )
(1 review)
61.60 LBS
38.60 (in)
11.00 (in)
7.50 (in)
Current Stock:

Complete pump end and motor set. Control panel (control box) sold separately.


  • HP: 5.5HP
  • Voltage: 230V Three Phase
  • Cycle: 60 Hz
  • Operating Amperage: 14.8A
  • Motor RPM: 3450 RPM
  • Stages: 12
  • Maximum Flow: 53 GPM
  • Maximum Head: 426 ft
  • Typical Flow: 26GPM @ 357ft; 37GPM @ 314ft; 48GPM @ 225ft
  • Suction Port: Center Suction
  • Discharge Port: 2 in
  • Built-in Check-valve: Yes
  • Housing Material: Stainless Steel
  • Impeller Material: Thermal Plastic
  • Motor Enclosure: Stainless steel
  • Duty: Continuous or up to 30 restarting cycles / hour
  • Control Box: Control Box (Control Panel) Optional
  • Weight: 61.6 lbs
  • Dimensions/Length: 58"
1 Year


  • 5
    Great Pump

    Posted by Leon Tackitt on 7th Aug 2016

    Planned on placing the pump at 400ft, but water level was too low, so we pushed it down to 500ft. Still pumping 21 gals a minute - SUPER! Info from Tuhorse: Thanks for the feedback for us to bring up this note to our potential buyers. The dead head of this pump is 426 feet. Mr. Tackitt set the pump at 500ft and still getting 21gpm because the water surface is at around 370 feet according to the pump curve for TH404512T230. Please do not expect this pump could pump any water if the water surface is over the dead head, 426 feet. There are two other 5.5HP models can be used for 400 to 500 feet water level, TH402320T230 or TH403018T230 and two 3HP models work for the depth but with less flow rate. TH400922T230, TH401517T230