10HP TS6-200-03 460V 3-Phase, Pump-end and Oil-Filled Motor, Stainless Steel Impellers

 Complete pump end and motor set. Control box (control panel) is not mandatory, but a three phase power switch with overload protection is required.

• HP: 10HP
• Voltage: 460V Three Phase
• Cycle: 60 Hz
• Operating Amperage: 15.5A
• Motor RPM: 3450 RPM
• Stages: 3
• Maximum Head (cut off): 200 ft
• Rated Flow: 200GPM
• Maximum Flow( 0-100 ft.): 290 GPM
• Free Flow Rate: 250GPM @ 130ft; 230GPM @ 140ft; 200GPM @ 158ft; 150GPM @ 178ft; 100GPM @ 190 ft.
• Suction Port: Center Suction
• Discharge Port: 4 inch NPT Female (4" to 3" NPT reducer sold separately if needed)
• Built-in Check-valve: Yes
• Housing Material: Stainless Steel 304
• Impeller Material: stainless steel 304
• Motor Enclosure: Stainless steel 304
• Discharge and Suction Port Material:  Stainless Steel 304
• Motor Bearing / Lubrication:  Ball bearing, Oil filled lubrication
• Duty: Continuous or allow maximum 15 restarting cycles / hour
• Control Box: Three phase power switch with overload protection is required(not included)
• Net Weight: 122 lbs
• Shipping weight: 129 Lbs
• Dimensions/Length(pump and motor assembly): 
• Shipping Dimensions:  Motor and pump separately packed

Minimum requirement for operating the motor is a non-fused 3-phase power switch and a 3-phase overload protector / Circuit breaker. The protector / breaker must be the type of those that shut off all 3-phase when one or more phase is overloaded. Do NOT use a fused switch that could burn out one of the phase. Do NOT use three individual 1-Phase breakers. You must use a real 3-phase protector / breaker or a protection device that does not cause phase loss (missing phase) problem.

* Not exactly as shown in photos due to stages and HP vary from models. Photos are taken from one of the 10HP for illustrations only.