10HP TS6-200-03 460V 3-Phase, Pump-end and Motor w/ Stainless Steel Impellers

SKU:
TS620003T460S
US$1,569.00
US$2,960.00
(You save US$1,391.00 )
(No reviews yet) Write a Review
Weight:
139.00 LBS
Condition:
New
Current Stock:

 Complete pump end and motor set. Control box (control panel) is not mandatory, but a three phase power switch with overload protection is required.

 

  • HP: 10HP
  • Voltage: 460V Three Phase
  • Cycle: 60 Hz
  • Operating Amperage: 15.5A
  • Motor RPM: 3450 RPM
  • Stages: 3
  • Maximum Head (cut off): 200 ft
  • Rated Flow: 200GPM
  • Maximum Flow( 0-100 ft.): 290 GPM
  • Free Flow Rate: 250GPM @ 130ft; 230GPM @ 140ft; 200GPM @ 158ft; 150GPM @ 178ft; 100GPM @ 190 ft.
  • Suction Port: Center Suction
  • Discharge Port: 3 inch NPT Female
  • Built-in Check-valve: Yes
  • Housing Material: Stainless Steel 304
  • Impeller Material: stainless steel 304
  • Motor Enclosure: Stainless steel 304
  • Discharge and Suction Port Material:  Stainless Steel 304
  • Motor Bearing / Lubrication:  Water lubricated thrust bearing, water filled lubrication
  • Duty: Continuous or allow maximum 15 restarting cycles / hour
  • Control Box: Three phase power switch with overload protection is required(not included)
  • Net Weight: 110 lbs
  • Shipping weight: 139 Lbs
  • Dimensions/Length(pump and motor assembly): 
  • Shipping Dimensions:

 

Minimum requirement for operating the motor is a non-fused 3-phase power switch and a 3-phase overload protector / Circuit breaker. The protector / breaker must be the type of those that shut off all 3-phase when one or more phase is overloaded. Do NOT use a fused switch that could burn out one of the phase. Do NOT use three individual 1-Phase breakers. You must use a real 3-phase protector / breaker or a protection device that does not cause phase loss (missing phase) problem.

Not exactly as shown in photos due to stages and HP vary from models. Photos are taken from one of the 10HP for illustrations only.

 

1 Year