10HP TH6-070-06 230V 3-Phase. Pump-end and Motor
Tuhorse
US$1,387.00
US$2,280.00
(You save
US$893.00
)
Complete pump end and motor set. Complete Instructions. Control Panel sold separately.
- HP: 10HP
- Voltage: 230V Three Phase
- Cycle: 60 Hz
- Operating Amperage: 26.4 A
- Motor RPM: 3450 RPM
- Stages: 6
- Rated Flow: 70GPM
- Maximum Flow: 88 GPM
- Maximum Head: 450 ft
- Typical Flow: 79GPM @ 267ft; 62GPM @ 350ft; 40GPM @ 410ft
- Suction Port: Center Suction
- Discharge Port: 2.5 inch NPTF
- Built-in Check-valve: Yes
- Housing Material: Stainless Steel
- Impeller Material: Thermal Plastic
- Motor Enclosure: Stainless steel
- Duty: Continuous or up to 20 restarting cycles / hour
- Control Box: Control Box (Control Panel) Optional
- Weight: 112.2 lbs
- Dimensions/Length: 49.75"
If you do not purchase a Tuhorse Control Panel for this pump, below is the mimimum requirement for operating and protecting the pump.
Minimum requirement for operating the motor is a non-fused 3-phase power switch and a 3-phase overload protector / Circuit breaker. The protector / breaker must be the type of those that shut off all 3-phase when one or more phase is overloaded. Do NOT use a fused switch that could burn out one of the phase. Do NOT use 3 x 1-Phase breakers, You must use a real 3-phase breaker that do not cause phase loss problem.
1 Year