3HP TH4-DF-06 460V 3-Phase. Pump-end and Motor

This pump will be replaced with TH4-045-07. New model has the same motor and uses 100% the same material but adding one extra stage for higher pressure. Old model has been proven good quality so new model would.  

Complete pump end and motor set. Control box (control panel) is not mandatory, but a three phase power switch with overload protection is required. Complete Instructions.

• Model: TH4-DF-06 T460V
• HP: 3HP
• Voltage: 460V Three Phase
• Cycle: 60 Hz
• Operating Amperage: 5.4 A
• Motor RPM: 3450 RPM
• Stages: 6
• Maximum Flow: 53 GPM
• Maximum Head: 213 ft
• Typical Flow: 26GPM @ 180ft; 37GPM @ 157ft; 48GPM @ 128ft; 54GPM @ 100ft;
• Suction Port: Center Suction
• Discharge Port: 2 in
• Built-in Check-valve: Yes
• Housing Material: Stainless Steel
• Impeller Material: Thermal Plastic
• Motor Enclosure: Stainless steel
• Duty: Continuous or up to 30 restarting cycles / hour
• Control Box: Three phase power switch with overload protection is required.
• Weight: 46.2 lbs
• Dimensions/Length: 41.5"

Minimum requirement for operating the motor is a non-fused 3-phase power switch and a 3-phase overload protector / Circuit breaker. The protector / breaker must be the type of those that shut off all 3-phase when one or more phase is overloaded. Do NOT use a fused switch that could burn out one of the phase. Do NOT use three individual 1-Phase breakers. You must use a real 3-phase protector / breaker or a protection device that does not cause missing phase problem.