returned from previous purchase for varies reasons. They were tested and recertified, confirmed to meet the specification.
If you have a hard time pulling your old 4 inch pump out of the well because the 4" steel well casing is rusted or the PVC casing is melted, consider to use a 3" pump instead.
This pump is also an ideal replacement for your jet pump. Go green, tired of priming your jet pump? get rid of your jet pump and use this higher efficient submersible!
- Fit 3 inch and larger ID well
- HP: 1HP
- Voltage: 230V Single Phase
- Cycle: 60 Hz
- Operating Amperage: 5.5 A
- Motor RPM: 3420 RPM
- Stages: 18
- Rated Flow: 10 GPM
- Maximum Flow: 14 GPM
- Maximum Head: 280 ft
- Typical Flow: 13.2GPM @ 141ft; 10.6GPM @ 190ft; 7.9GPM @ 226ft; 5GPM @ 251ft
- Suction Port: Center Suction
- Discharge Port: 1 inch NPT
- Built-in Check-valve: Yes, but an external check valve is required in water tight systems
- Housing Material: Stainless Steel 304
- Impeller Material: Thermal Plastic
- Motor Enclosure: Stainless steel 304
- Motor Lead: 4 wires (3 wire + 1 ground)
- Duty: Continuous or up to 30 restarting cycles / hour
- Control Box: Dual capacitor control box
- Weight: 26 lbs.
- Shipping weight: 38lbs
- Packaging: 44" x 10" x 8"
- Dimensions/Length: 113cm long, 7.3 cm diameter (44.5" long, 2.87" diameter)