Loading... Please wait...

Our Newsletter


CS Series 135/4 - 1/2HP 115V Well Pump - returned from previous purchase 90 days Warranty

Retail Price:
$238.80
$125.00 (You save $113.80)
SKU:
CS10135
Brand:
Condition:
New
Weight:
17.16 LBS
Rating:
Shipping:
Calculated at checkout


Product Description

Discounted price. Pump was returned from previous purchase due to application mismatch or other varies reasons. It has been tested in good working condition. This is a discontinued item, 90 days warranty.

 

IMPORTANT INFORMATION FOR PRESSURE TANK USERS:
The listed product is best suited for high flow and medium-low pressure applications. The pump is commonly used for free flow, or distributing water from a cistern to sprinklers or a home at the same elevation.
If the pump is used with pressure tank, please carefully review the "Pressure Setting with Maximum Lift Table" below. Operation outside of these parameters will cause damage to the pump. 

 

Pressure Setting with Maximum Lift Table
CS10-135/4   (58PSI at 0 feet of head)
Pressure switch cut off setting Max. Lift (source water level to tank in vertical feet)
cut off at 60 psi Not supported
cut off at 50 psi 10 feet
cut off at 45 psi 20 feet
cut off at 40 psi 30 feet
cut off at 35 psi 40 feet
   
Examples:   
If pressure switch setting is 20 on, 40 off 
this pump can be used for up to 30 feet.
In a free flow application, up to 120 feet.

 

Tuhorse brand single piece 1/2 HP submersible water pump, suitable for use in cisterns, lakes, or wells.

This is a 2-wire motor (2 hot wires and 1 ground). No control box required.

Complete water pump end with built-in motor, it is a single piece unit, with removable stand. 

  • HP: 0.50HP
  • Voltage: 115V
  • Cycle: 60 Hz
  • Operating Amperage: 6.8 A
  • Motor RPM: 3450 RPM
  • Stages: 4
  • Maximum Flow: 23 GPM
  • Maximum Head: Pump water up to 120 feet free flow or 30 feet in a system with a pressurized tank set at 40psi cut off.
  • Typical Flow: Rated at 15 GPM, maximum of 23 GPM.
  • Suction Port: Bottom
  • Discharge Port: 1.25 in
  • Built-in Check-valve: Yes
  • Housing Material: Stainless Steel
  • Impeller Material: Condensed Thermal Plastic
  • Motor Enclosure: Stainless Steel
  • Cooling: Water flowing over motor, (minimum 2GPM for sufficient cooling in continuous duty)
  • Duty: Continuous or up to 30 restarting cycles / hour
  • Control Box: Not required
  • Weight: 17.16 lbs
  • Dimensions/Length: Height: 21" without stand. 25.25" with stand. Diameter - Pump body diameter: 3.875". Stand Diameter: 5".

Warranty Information

6 Months

Find Similar Products by Category

Write your own product review

Product Reviews

  1. Best pump for low current draw 5 Star Review

    Posted by on 7th Jan 2013

    Great submersible pump. Easy installation and less expensive than most competitors. The lower current draw means lower electric bills.


Add to Wish List

Click the button below to add the CS Series 135/4 - 1/2HP 115V Well Pump - returned from previous purchase 90 days Warranty to your wish list.

You Recently Viewed...